SWIR filter (Broadband filter) Short wavelength infrared (SWIR) light is generally defined as light in the 900-1700 nm wavelength range. SWIR filter is known to be used for foreign object and semiconductor inspection. Our products can be used as a wavelength selective filter for products with infrared image sensors (IMX990/IMX991). If you have any interest in this filter, please contact us.
Steep-Edge Long Pass Filters Steep-edge Long Pass Filters provide very steep cut-on slope, deep rejection and high transmission at the same time. These filters are made by using dielectric thin films only without employing any absorbing filter glasses. Custom cut-on wavelengths and custom sizes are available on request. Sharp transition is useful for separation of exitation light and emission in various spectral analysis including fluorescence analysis. LPF600 (%T) LPF600 (OD) Non-Polarized LPF525 45deg.(％T)
Notch filters Notch filters, or band stop filters, reflect and remove the specific narrow wavelength band only and pass the other wavelength range. Our notch filters have not only narrow rejection band and wide pass band, but also small polarization dependence at incident angle of 45 degrees. We will design the filters in accordance with your demands and will propose the best solution for the center wavelength and bandwidth of rejection band, pass bandwidth, and so on.
Low incident angle dependence band pass fitlers The transmission spectrum of band pass filters composed of multi-layered dielectric thin films subject to change depending on the incident angle of light. Usually, pass band slides to the shorter wavelength side by 20nm to 35nm when the incident angle changes from 0 degrees to 30 degrees. Low incident angle dependence band pass filters reduce this wavelength shift to less than a half and minimize the variation of the optical characteristics of the optical filter. You can specify the center wavelengths of the low incident angle dependence band pass filters according to the laser wavelength applied to your system. Multi-band […]
We are constantly striving to improve our optical thin-film coating technologies and the adaptability to a variety of requests for custom products. Recent achievements cover a wide range of applications including LiDAR(light detection and ranging) laser sensing system, Raman spectroscopy and multi-spectral cameras. Our technical team will work with you to design the optical filter so the specifications meet the demands of your product and make the price reasonable. We welcome any challenging requirements for custom optical filters such as non-standard spectral shapes, extremely large blocking, polarization independence, low incident angle dependence, and so on. LiDAR – Low angle-dependence band pass filters Spectral analsis I – Notch filters Spectral analysis […]
Narrow Band Pass Filter Abundant experiences of customized optical filters for the optical communication and fiber-optic sensing have expanded the variation of the bandpass filters: ・1 cavity type – 5 cavity type are selectable. ・Narrow band width ― FWHM < 1nm ― is available 1 Cavity BPF BWO11-1.44 3 Cavity BPF BWP34-1.56 Wider Band Pass Filter Koshin’s remarkable design technology enable the bandpass filters to move over 10nm maintaining the wider FWHM. ・Small variation of FWHM. ・Very few ripple generation. 2 Cavity BPF BWO20-1.55 5 Cavity BPF BWJ55-1.31 Wide Tuning Range Filter Very wide tuning range realizes the custom bandpass filter that can change both the center wavelength and the FWHM. […]